Maytag Dishwasher Troubleshooting Made Simple

Maytag dishwasher troubleshooting is something which anyone using this machine can do easily. The day-to-day problems can be first tackled by simple steps before referring any teething issues to the service experts. One of the frequent troubles is when the dishes are not cleaned and the residue is left even after many washing cycles. The problem is not resolved even when the user has applied different detergents and running the dishwasher cleaners through multiple cycles. Usually, this kind of problem is observed in the dishwashers, which are bought for more than 5 years. For example, model MDB5100AWQ bought in 2002 has been observed to have such issues. The best maytag dishwasher troubleshooting tip in such scenario is to either clean the filters or install a new one. Getting a new set of filters installed in the machine is helpful as the older ones are usually over their expected useful life. Ensuring that the hot water is connected to the dishwasher as well as installing new ‘O’ rings made of rubber on the spin arm sockets are few of other maytag dishwasher troubleshooting tip to ensure this problem is resolved.

One of the frequent issues with maytag dishwashers is the issues with the draining. In this case, the water remains there in the bottom of the machine even after the drainage process is conducted. This standing water is not removed even after the hoses are replaced and flushed, and the machine is run again. The users usually suspect that the pump is at fault at go on to get it replaced, while few simple maytag dishwasher troubleshooting steps can resolve the issue, unless pump is really the cause of trouble. The first step in maytag dishwasher troubleshooting to rectify this issue is to check for the filter clogging. Filter clogging can be checked out removing the spray arm and hence the filter cover. Spray arm is covered by a threaded cap, located in the center of the arm. This cap needs to be unscrewed, followed by removal of star shaped screws out of the filter cover. The filter is round shaped, and grips the pump housing at its outer edge. The user needs to lift the filter out, clean it and fit it back into the assembly by reversing the process explained above in removing it. This is the most generic maytag dishwasher troubleshooting for this kind of issues.

Water not getting into the dishwasher is another frequent issue, which plagues these dishwashers. The user complaint for such issues is that no water gets into the dishwasher to clean the dishes even though the wash cycles are initiated and the usual sound of the operating dishwasher is heard. Maytag dishwasher troubleshooting in such scenarios needs the user to check for few things. The first of all is to verify the level of the water float. This is an automation installed in the machine, which gives the feedback to the dishwasher about the level of water in it. If the water float movement is clogged due to dirt and remains of residue, it gets stuck at a level, which wrongly indicates to the machine that the water is at the full level. The user conducting the maytag dishwasher troubleshooting for such issue should push this float down to the level of machine floor. Keep pushing and pulling the float to clear any residue clogging the stem of the float to ease the movement of it. This would ease the float movement with the level of water and hence the water inlet issue would be resolved thus successfully completing the steps of this maytag dishwasher troubleshooting.

Related Pages